ÉTS News

Student Activities

More news on the same subject

Divine uwonkunda

May 03, 2024

Faciliter l’intégration des étudiant(e)s internationaux grâce au Programme Contact

Research and Innovation

More news on the same subject

3D-printed prototype part using advanced materials.

January 03, 2016

Designing a Drone Frame Assembly Using 3D Printing

Industrial plant with multiple smokestacks emitting steam against a clear sky.

October 21, 2015

Deep Geothermal Energy: A Potential not Fully Exploited

Press Room

More news on the same subject

Team presents race car project to visitors in university tech lab.

February 20, 2023

Inauguration of Pavilion D

Recent News

Advanced drone technology at sunset exemplifies innovation in flight and robotics.

September 23, 2016

Applying the B Control to a Quadcopter

Student surrounded by books and notes, studying on a laptop.

September 19, 2016

Information Retrieval, Where to Begin?

A healthcare professional examines an X-ray, showcasing advanced medical technology education.

August 22, 2016

Optimizing Spinal Implants through Modeling

Wing of an aircraft soaring above clouds, symbolizing the heights of engineering and technology.

May 30, 2016

Real-Time Testing of a Morphing Wing Model in a Wind Tunnel

"Progressive motion of a figure, symbolizing innovation and dynamic learning in a tech-forward university setting."

May 24, 2016

The Digital Human and its Use in Workplace Design and Ergonomics

Advanced sailing technology demonstrates hydrodynamic prowess on water with mountainous backdrop.

April 04, 2016

Design and Additive Manufacturing of Mast Foot and Support for a C-Class Catamaran

Soaring high, this view captures the vastness of Earth's terrain from above, urging technological innovation.

March 14, 2016

Fuel Consumption Computation to Optimize the Trajectory of Aircraft

Turboprop aircraft in flight, showcasing advanced aeronautical engineering.

February 29, 2016

Morphing Wing Design to Reduce Airplane Fuel Consumption

3D-printed prototype part using advanced materials.

January 03, 2016

Designing a Drone Frame Assembly Using 3D Printing

Industrial plant with multiple smokestacks emitting steam against a clear sky.

October 21, 2015

Deep Geothermal Energy: A Potential not Fully Exploited